A.W. GibbsPortland, Oregon
Model Engineering / Projects / Bar Stock Wobbler Steam Engine
Model Engineering · Project · Model

Bar Stock Wobbler Steam Engine

Quinn Dunki's lathe-buildable steam engine: an oscillating-cylinder engine, a "wobbler", made entirely from bar stock with nothing but a lathe. Nine turned and drilled parts in brass and steel, plus a spring, washer and nut on the cylinder pivot. The frame is the valve: as the cylinder rocks on its pivot, its one port swings back and forth across the inlet and exhaust ports drilled in the frame's face.
DesignQuinn Dunki · Blondihacks
Length4.5 in
ScaleFull size
StatusQueued
Bar Stock Wobbler Steam Engine
RENDER from the CAD model
Parts indexAssembliesJournalShop logGallery

Parts index

12 parts · 0 finished · 0 in work
0 / 12 parts complete · 0%
Click No., Part, or Stock to sort — e.g. sort by Stock to see every casting, or every 1/8″ brass part, grouped together.
No.PartStockStatus
No.PartStockStatus
1 Frame PRINT 🔒 3/4 x 3/8 brass flat Queued
2 Cylinder PRINT 🔒 1 dia brass or bronze Queued
3 Piston PRINT 🔒 1/2 dia brass Queued
4 Cylinder pivot PRINT 🔒 3/16 drill rod Queued
5 Crank web PRINT 🔒 1 dia steel Queued
6 Crankshaft PRINT 🔒 1/4 drill rod Queued
7 Crank pin PRINT 🔒 1/8 drill rod Queued
8 Flywheel PRINT 🔒 2 dia brass or steel Queued
9 Air/steam fitting PRINT 🔒 5/16 dia brass Queued
10 Pivot spring Compression spring, .300 OD x .025 wire Queued
11 Pivot washer #10 SAE flat washer Queued
12 Pivot nut 10-32 hex nut Queued
🔒 Drawings & CAD locked. This is a Quinn Dunki · Blondihacks design — the sheets and models are the designer’s copyright, so they open for the site owner only. The build log and photographs are open to everyone.

Assemblies

1 assembly

Journal

0 entries

Shop log

No sessions logged yet.